Bissel proheat model 25a3 2 10082c will not pump water to the floor cleaner.
Bissell carpet cleaner pump not working.
You should be able to see the pump belt looped around the motor shaft.
It may take up to 20 seconds before you see the spray.
You may have a bad pump clogged hoses or a clogged heater.
I checked for all of those and this turned out to.
Examine the belt for breakage.
As with all pumps the pump on the bissell 2x proheat needs to be primed.
Pumps ok to wand.
Followed all instructions in the manual cleaned all parts and inspected belt which is ok.
You may have a bad pump clogged hoses or a clogged heater.
If you see this.
There are many videos out there on the bissell.
There is often a small rubber nozzle that sits in the base of the cleaner that the soap water dispenser sits into.
Visit our service carpet cleaning bissell carpet cleaner won t spray.
The bissell powersteamer is a carpet cleaner that uses hot water and cleaning solution to pull ground in dirt and debris out of carpet upholstery and other surfaces in the home.
Without a tool connected to the hose press the trigger until it sprays strongly.
If you mark that the soap solution is not spraying turn off your bissell carpet cleaner as early as possible.
If broken or missing refer to page 17 replacement parts in your user guide.
If the rubber nozzle isn t positioned just so or if it s missing the cleaner will not spray water or cleaner.
Easy repair bellevue wa there are many videos out there on the bissell.
Make sure that the water tank is full.
If you still did not get the hose to spray you will need to check to see if the pump belt is broken.
Bissell carpet cleaner won t spray.
Take the entire hose below the clean tank to allow the fluid to spray.
Remove the tank and set it aside.
I checked for all of those and this turned out to be my problem.
There is no water flowing in the tubing to the dispersal ports from the reservoir tank.
If there is air in the pump where water should be as there was when the machine was used for the first time you should turn the cleaner off and wait for one minute.
The powersteamer uses a two in one tank to combine the water and cleaning solution which is activated using a trigger on the unit handle.
See our belt changing video for help.