Best Tool For Removing Carpet Tack Strips

Pull the pry bar free and remove the putty knife if you re using one.

Best tool for removing carpet tack strips.

After pulling up your carpet you will most likely have tack strips left around the perimeter of the room. Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. Wide to tuck the edge of the carpet down against the baseboard. To remove tack strip just pop it up with a flat pry bar.

Press the pry bar in order to begin lifting the tack strip. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. The installer needs a gap at least 1 4 in.

Carpet tack strips can usually remain in place but look for rust rot or other damage. Continue like this until you have. If you are pulling up carpet from stairs. Pick somewhere to start either a corner or a break between two tack strips.

Begin at the top of the stairs. At those points slide a pry bar under the tack strip. Reinsert them beside the next nail on the tack strip and pop that nail out the same way. You should also remove the tack strip if it s less than 1 4 in.

Rust can bleed through the carpet creating stains on the surface. Some people have a hard time with this step but i ll show you how to remove carpet tack strips the easy way with three simple tools. Roll or fold the strip secure with duct tape and remove it from the room.